Norwest, NSW · 2153
Ducted Air Conditioning Norwest
Luxe Air installs ducted reverse-cycle air conditioning across Norwest, using Daikin and Mitsubishi Electric inverter systems zoned around how your home is actually used. Most installs take one to three days, and every quote is a fixed price after we've measured up on site.
- ARCtick Certified Fully licensed & compliant
- Australian Owned Proudly local
- Premium Brands Daikin, Mitsubishi & more
- Fast Local Service Same-week across Hills District
Pricing
What ducted air conditioning costs in Norwest
Indicative installed pricing for Norwest homes. Every job is a fixed-price quote after an on-site measure. The bands below are where most jobs land.
-
3-bedroom, single storey
$11,000 – $13,000
The typical entry point for a whole-home system
- Daikin or Mitsubishi Electric inverter unit
- 4 zones, 6–8 ceiling outlets
- Standard ceiling-cavity install
- Zone controller + electrical circuit
-
4-bedroom family home
$13,000 – $16,000
The most common Norwest ducted job
- Larger-capacity inverter system
- 4–6 zones, 8–10 outlets
- Single or double storey
- Touch-panel controller, full commissioning
-
Large or double storey
$16,000+
Bigger homes, more zones, tighter cavities
- High-capacity or two-system design
- 6–8 zones, 12+ outlets
- Slim-line bulkheads where cavity is tight
- Upstairs / downstairs zoned independently
Your exact price depends on your home. Get it in 60 seconds.
Get Your Exact PriceWhat moves the number up or down
- System capacity (kW) sized to room area, insulation and exposure
- Number of zones (more zones = more dampers + more controller channels)
- Number and type of vents (linear-bar bulkheads cost more than square)
- Single-storey vs double-storey (more duct runs, longer install)
- Ceiling cavity height (slim-line vs standard chassis)
- Outdoor unit location and access (slab, wall bracket, roof)
- Electrical capacity (existing board upgrade if required)
- Removal and disposal of any existing system
- After-hours or weekend install premium
Local knowledge
Ducted in Norwest homes
Ducted work in Norwest concentrates in the precinct's freestanding homes and larger townhouses, since apartments rarely have the roof space for it. The freestanding stock is modern two-storey construction where we run 4–6 zones with upstairs and downstairs controlled independently, planning duct runs around the compact ceiling voids modern builds leave. In townhouses we assess the roof cavity honestly first: where it is too tight for ducted done properly, a multi-head split is the better system and we say so.
Norwest's heat profile is inland Hills all the way: 35–40°C afternoons, no sea breeze, and modern dark roofs that load upper storeys hard by evening. We size ducted plant to measured load including the big glazing areas modern designs favour, and spec insulated duct rated for hot roof spaces. Zoning keeps running costs in check at roughly $2–$4 per hour whole-home, and lets a work-from-home household condition one office zone all day instead of the entire house.
Scope of work
What's included, and what's not
What this service includes
- On-site measure, room-by-room sizing, written zoned-layout proposal
- Daikin or Mitsubishi Electric inverter ducted indoor + outdoor unit
- Insulated flexible ductwork, slim-line bulkheads where cavity is tight
- Low-profile ceiling vents (linear-bar or square as specified)
- Touch-panel zone controller + wall-mounted thermostat
- Dedicated electrical circuit and isolator (licensed in-house electrician)
- Pressure-test, refrigerant charge, commissioning, controller walkthrough
- Manufacturer warranty registration + ARCtick refrigerant compliance docs
Not included (quoted separately if needed)
- Plasterboard / cornice patching beyond standard touch-up
- Re-painting after vent or controller installation
- Roof penetrations on tile roofs (separate trade required where structural)
- Solar / battery integration (quoted separately)
- Removal and disposal of system older than 15 years (asbestos check required)
- Annual servicing (sold separately as a maintenance plan)
Process
How a ducted job runs in Norwest
- 01
On-site measure & quote
We walk the home, measure rooms, check ceiling cavity height, and propose a zoned layout sized to your insulation and exposure.
- 02
System selection
Daikin or Mitsubishi Electric inverter ducted units, sized so the system runs efficiently rather than flat-out at peak.
- 03
Installation
Typically 1–3 days. Indoor fan coil in the ceiling, outdoor condenser on a slab or wall bracket, ducting and vents fitted, touch-up and clean as we go.
- 04
Commissioning & handover
Pressure-tested, charged, zoning verified room-by-room, controller walkthrough, manufacturer warranty registered.
No site visit needed to start
See your ducted price band before we visit
Drop your address into the calculator and it will size the job from your home's footprint, then show you a price band in about 60 seconds. The on-site measure locks in the fixed price.
Frequently asked
Common questions about ducted air conditioning in Norwest
How much does ducted air conditioning cost in Norwest?
Most 4-bedroom Norwest homes land between $13,000 and $16,000 installed; compact single-storey homes start around $11,000 and large double-storey jobs run $16,000+. Fixed-price quote after the on-site measure, so there are no surprises.
Can ducted air conditioning be retrofitted into an older Norwest home?
Yes. Most single and double-storey Norwest homes have enough ceiling cavity for a standard ducted system. Where post-war cavity height is tight, a slim-line bulkhead install solves it.
How many ducted zones does an Norwest home need?
Most Norwest homes work with 4–6 zones: living, kitchen, master, kids' rooms and rumpus. Independent zone control means you only condition occupied rooms, cutting running cost.
How long does a ducted install take in Norwest?
Most Norwest installs are 1–3 working days. Day 1 is duct and vent fit-out, day 2 is unit placement and refrigerant pipework, day 3 is electrical, commissioning and clean-up.
Do you handle the electrical work for a ducted install in Norwest?
Yes. Our licensed electrician runs the dedicated circuit, isolator and controller wiring as part of the ducted install. One contractor, one invoice, one warranty.
Is ducted air conditioning worth it in Norwest?
For a 3–4 bedroom Norwest home you plan to stay in, usually yes. You get one quiet system, no wall units, and zoning keeps running costs close to two or three splits. For a single room or a rental, a split system wins on upfront cost.
What does ducted air conditioning cost to run in Norwest?
A zoned inverter system typically runs $2–$4 per hour cooling the whole home, and much less conditioning one or two zones. Correct sizing is the biggest factor here, because an oversized system short-cycles and costs more.
More services in Norwest
Every air conditioning service, in one local team
-
Split System Air Conditioning Norwest
Wall-mounted reverse-cycle splits for single rooms or multi-head setups for 2–4 rooms.
Read more -
Air Conditioning Repairs Norwest
Same-week diagnostics and repairs for all major brands across split, ducted and multi-head systems.
Read more -
Air Conditioning Servicing & Maintenance Norwest
Annual preventive servicing to keep efficiency high and breakdowns rare.
Read more
See the Norwest air conditioning hub or our full Hills District page for every suburb.
Recommended next step
Price your ducted job in Norwest in 60 seconds
Drop your address into the calculator for an instant size and price band, or send through photos for a full fixed-price quote. Same-day response in business hours.