Call 1300 322 093 Instant price
A bright living room with a wall-mounted split-system air conditioner

Stanmore, NSW · 2048

Ducted Air Conditioning Stanmore

Luxe Air installs ducted reverse-cycle air conditioning across Stanmore, using Daikin and Mitsubishi Electric inverter systems zoned around how your home is actually used. Most installs take one to three days, and every quote is a fixed price after we've measured up on site.

  • ARCtick Certified Fully licensed & compliant
  • Australian Owned Proudly local
  • Premium Brands Daikin, Mitsubishi & more
  • Local Service Across Inner West

Pricing

What ducted air conditioning costs in Stanmore

Indicative installed pricing for Stanmore homes. Every job is a fixed-price quote after an on-site measure. The bands below are where most jobs land.

  • 3-bedroom house

    $11,000 – $13,000

    Single storey; the typical entry point for a whole-home system

    • Daikin or Mitsubishi Electric inverter unit
    • 4 zones, 6–8 ceiling outlets
    • Standard ceiling-cavity install
    • Zone controller + electrical circuit
  • 4-bedroom house

    $13,000 – $16,000

    The most common Stanmore ducted job

    • Larger-capacity inverter system
    • 4–6 zones, 8–10 outlets
    • Single or double storey
    • Touch-panel controller, full commissioning
  • 5-bedroom or double storey

    $16,000+

    Bigger homes, more zones, tighter cavities

    • High-capacity or two-system design
    • 6–8 zones, 12+ outlets
    • Slim-line bulkheads where cavity is tight
    • Upstairs / downstairs zoned independently

Our ducted air conditioning cost calculator prices your home from its address in 60 seconds.

Get Your Exact Price

What moves the number up or down

  • System capacity (kW) sized to room area, insulation and exposure
  • Number of zones (more zones = more dampers + more controller channels)
  • Number and type of vents (linear-bar bulkheads cost more than square)
  • Single-storey vs double-storey (more duct runs, longer install)
  • Ceiling cavity height (slim-line vs standard chassis)
  • Outdoor unit location and access (slab, wall bracket, roof)
  • Electrical capacity (existing board upgrade if required)
  • Removal and disposal of any existing system
  • After-hours or weekend install premium
Ceiling outlets in a renovated living area

Local knowledge

Ducted in Stanmore homes

Stanmore is one of the easier Inner West suburbs for ducted, because the Federation villas and double-fronted Victorians were built with tall pitched roofs and a central hallway that makes an obvious spine for the ductwork. The fan coil sits above the hall, supply runs branch to each room, and the return air grille goes in the hallway ceiling where it is least noticed. The care is in the ceilings: many rooms still carry pressed metal or ornate plaster, so we place outlets in the plainest sections or in the rear extension and leave the decorative work alone. A single-fronted terrace with a low skillion at the back usually gets a multi-head split instead.

Zoning in Stanmore follows the way these houses were extended: original bedrooms at the front under the high roof, and a kitchen-living space opened up at the back, often with a glass wall onto the yard. Two or three zones split those halves so the bedrooms cool overnight while the living area rests, at roughly $1–$2 per hour when the whole home runs. The outdoor unit goes at the rear or down the side passage, never on the street elevation, keeping the heritage streetscape intact and the compressor out of earshot of the front verandah. The driver is a still, humid summer with windows shut against Parramatta Rd traffic and aircraft, when plane-tree shade stops being enough by mid-afternoon.

Scope of work

What's included, and what's not

What this service includes

  • On-site measure, room-by-room sizing, written zoned-layout proposal
  • Daikin or Mitsubishi Electric inverter ducted indoor + outdoor unit
  • Insulated flexible ductwork, slim-line bulkheads where cavity is tight
  • Low-profile ceiling vents (linear-bar or square as specified)
  • Touch-panel zone controller + wall-mounted thermostat
  • Dedicated electrical circuit and isolator (licensed in-house electrician)
  • Pressure-test, refrigerant charge, commissioning, controller walkthrough
  • Manufacturer warranty registration + ARCtick refrigerant compliance docs

Not included (quoted separately if needed)

  • Plasterboard / cornice patching beyond standard touch-up
  • Re-painting after vent or controller installation
  • Roof penetrations on tile roofs (separate trade required where structural)
  • Solar / battery integration (quoted separately)
  • Removal and disposal of system older than 15 years (asbestos check required)
  • Annual servicing (sold separately as a maintenance plan)

Process

How a ducted job runs in Stanmore

  1. 01

    On-site measure & quote

    We walk the home, measure rooms, check ceiling cavity height, and propose a zoned layout sized to your insulation and exposure.

  2. 02

    System selection

    Daikin or Mitsubishi Electric inverter ducted units, sized so the system runs efficiently rather than flat-out at peak.

  3. 03

    Installation

    Typically 1–3 days. Indoor fan coil in the ceiling, outdoor condenser on a slab or wall bracket, ducting and vents fitted, touch-up and clean as we go.

  4. 04

    Commissioning & handover

    Pressure-tested, charged, zoning verified room-by-room, controller walkthrough, manufacturer warranty registered.

No site visit needed to start

See your ducted price band before we visit

Drop your address into the calculator and it will size the job from your home's footprint, then show you a price band in about 60 seconds. The on-site measure locks in the fixed price.

Service area

Ducted Air Conditioning across the Inner West

Looking for ducted air conditioning near Stanmore? See ducted air conditioning across Inner West for every suburb we cover there.

Frequently asked

Common questions about ducted air conditioning in Stanmore

What affects a ducted quote for my Stanmore home?

Victorian terraces and villas from the 1880s–1900s, Federation cottages and double-fronted houses, a handful of interwar flat blocks near the stations, and newer apartments along the Parramatta Rd frontage. We confirm roof space, room sizes and the proposed zones on site. The installed price bands above are a starting point; the measured layout determines the fixed quote.

What local conditions should the ducted design account for?

Stanmore sits far enough from the coast that summer afternoons arrive hot and still with no reliable sea breeze, but the mature plane trees along many streets take the edge off in a way the newer apartment precincts nearby never get. Traffic on Parramatta Rd and the aircraft approach over parts of both suburbs push residents to keep windows shut, which turns a well-shaded house into a warm one by evening. Humid nights follow, so bedrooms need proper cooling rather than a ceiling fan.

Can an existing Stanmore ducted system be upgraded?

We inspect the existing ducts, insulation and controls before deciding what can be reused. Include a floor plan and the old unit’s model label when requesting a quote, particularly if extensions have changed the rooms the system serves.

Recommended next step

Price your ducted job in Stanmore in 60 seconds

Drop your address into the calculator for an instant size and price band, or send through photos for a full fixed-price quote. Same-day response in business hours.