Call 1300 322 093 Instant price
A bright living room with a wall-mounted split-system air conditioner

Edmondson Park, NSW · 2174

Ducted Air Conditioning Edmondson Park

Luxe Air installs ducted reverse-cycle air conditioning across Edmondson Park, using Daikin and Mitsubishi Electric inverter systems zoned around how your home is actually used. Most installs take one to three days, and every quote is a fixed price after we've measured up on site.

  • ARCtick Certified Fully licensed & compliant
  • Australian Owned Proudly local
  • Premium Brands Daikin, Mitsubishi & more
  • Local Service Across Liverpool

Pricing

What ducted air conditioning costs in Edmondson Park

Indicative installed pricing for Edmondson Park homes. Every job is a fixed-price quote after an on-site measure. The bands below are where most jobs land.

  • 3-bedroom house

    $11,000 – $13,000

    Single storey; the typical entry point for a whole-home system

    • Daikin or Mitsubishi Electric inverter unit
    • 4 zones, 6–8 ceiling outlets
    • Standard ceiling-cavity install
    • Zone controller + electrical circuit
  • 4-bedroom house

    $13,000 – $16,000

    The most common Edmondson Park ducted job

    • Larger-capacity inverter system
    • 4–6 zones, 8–10 outlets
    • Single or double storey
    • Touch-panel controller, full commissioning
  • 5-bedroom or double storey

    $16,000+

    Bigger homes, more zones, tighter cavities

    • High-capacity or two-system design
    • 6–8 zones, 12+ outlets
    • Slim-line bulkheads where cavity is tight
    • Upstairs / downstairs zoned independently

Our ducted air conditioning cost calculator prices your home from its address in 60 seconds.

Get Your Exact Price

What moves the number up or down

  • System capacity (kW) sized to room area, insulation and exposure
  • Number of zones (more zones = more dampers + more controller channels)
  • Number and type of vents (linear-bar bulkheads cost more than square)
  • Single-storey vs double-storey (more duct runs, longer install)
  • Ceiling cavity height (slim-line vs standard chassis)
  • Outdoor unit location and access (slab, wall bracket, roof)
  • Electrical capacity (existing board upgrade if required)
  • Removal and disposal of any existing system
  • After-hours or weekend install premium
Ceiling outlets in a renovated living area

Local knowledge

Ducted in Edmondson Park homes

Ducted in Edmondson Park is designed for the two-storey project home because that is what the suburb is. The fan coil goes into the roof near the upstairs hatch, where the cavity is shallow and crowded with trusses, and insulated flexible duct is run to each upstairs bedroom by the shortest route the framing allows, with a return air in the upstairs hallway so the top floor is treated as its own zone. The ground floor has no cavity above it, so the living, kitchen and any downstairs bedroom are fed through a bulkhead along the hallway or a dropped ceiling, which on a frame-stage build we set out with the builder so it disappears into the design. Upstairs and downstairs are zoned separately as a minimum, and larger plans get the master retreat on its own zone.

The heat load is dictated by orientation, because there is no shade in Edmondson Park yet. A west-facing living room with an alfresco slider and minimal eave takes direct sun from early afternoon, so we size to that glass rather than to the floor area, and we would rather explain why a bigger fan coil is needed than fit an undersized one that runs flat out at 42°C. The condenser is a slim unit on a bracket or compact pad in the setback, kept clear for airflow and angled away from the neighbour, or in the courtyard on a townhouse. Running cost is roughly $1–$2 per hour whole-home, and most families here run only the bedroom zone overnight and the living zone through the afternoon, which keeps the summer bill well below what a pair of builder splits would have cost to run.

Scope of work

What's included, and what's not

What this service includes

  • On-site measure, room-by-room sizing, written zoned-layout proposal
  • Daikin or Mitsubishi Electric inverter ducted indoor + outdoor unit
  • Insulated flexible ductwork, slim-line bulkheads where cavity is tight
  • Low-profile ceiling vents (linear-bar or square as specified)
  • Touch-panel zone controller + wall-mounted thermostat
  • Dedicated electrical circuit and isolator (licensed in-house electrician)
  • Pressure-test, refrigerant charge, commissioning, controller walkthrough
  • Manufacturer warranty registration + ARCtick refrigerant compliance docs

Not included (quoted separately if needed)

  • Plasterboard / cornice patching beyond standard touch-up
  • Re-painting after vent or controller installation
  • Roof penetrations on tile roofs (separate trade required where structural)
  • Solar / battery integration (quoted separately)
  • Removal and disposal of system older than 15 years (asbestos check required)
  • Annual servicing (sold separately as a maintenance plan)

Process

How a ducted job runs in Edmondson Park

  1. 01

    On-site measure & quote

    We walk the home, measure rooms, check ceiling cavity height, and propose a zoned layout sized to your insulation and exposure.

  2. 02

    System selection

    Daikin or Mitsubishi Electric inverter ducted units, sized so the system runs efficiently rather than flat-out at peak.

  3. 03

    Installation

    Typically 1–3 days. Indoor fan coil in the ceiling, outdoor condenser on a slab or wall bracket, ducting and vents fitted, touch-up and clean as we go.

  4. 04

    Commissioning & handover

    Pressure-tested, charged, zoning verified room-by-room, controller walkthrough, manufacturer warranty registered.

No site visit needed to start

See your ducted price band before we visit

Drop your address into the calculator and it will size the job from your home's footprint, then show you a price band in about 60 seconds. The on-site measure locks in the fixed price.

Frequently asked

Common questions about ducted air conditioning in Edmondson Park

What affects a ducted quote for my Edmondson Park home?

2010s and 2020s two-storey project homes on lots of 300 to 450 square metres across most of the suburb, townhouse rows near the station and the town centre, mid-rise apartments at Ed.Square, and a few larger house-and-land blocks on the Denham Court and Bardia edges. We confirm roof space, room sizes and the proposed zones on site. The installed price bands above are a starting point; the measured layout determines the fixed quote.

What local conditions should the ducted design account for?

Edmondson Park gets the south-western summer: runs of days above 35°C, some past 40°C, no sea breeze, and warm evenings because the suburb is still all roofs, driveways and road. Dark roofs and small eaves leave west-facing living rooms in afternoon sun and upstairs bedrooms under a cavity hot all night. Still July mornings sit in low single digits with frost toward Denham Court, so reverse-cycle heating works hard.

Can an existing Edmondson Park ducted system be upgraded?

We inspect the existing ducts, insulation and controls before deciding what can be reused. Include a floor plan and the old unit’s model label when requesting a quote, particularly if extensions have changed the rooms the system serves.

Recommended next step

Price your ducted job in Edmondson Park in 60 seconds

Drop your address into the calculator for an instant size and price band, or send through photos for a full fixed-price quote. Same-day response in business hours.